https://wiki.gude-systems.com/index.php?action=history&feed=atom&title=Ftdi_sio.ko 2026-05-21T20:08:19Z Versionsgeschichte dieser Seite in Gude Systems GmbH MediaWiki 1.35.2 https://wiki.gude-systems.com/index.php?title=Ftdi_sio.ko&diff=133&oldid=prev 2013-03-07T19:01:43Z

<p>Die Seite wurde neu angelegt: „to enable support for FTDI&#039;s USB serial converter, you need to enable USB Serial Converter support ---&gt; &lt;M&gt; USB FTDI Single Port Serial Driver (EXPERIME…“</p> <p><b>Neue Seite</b></p><div>to enable support for FTDI's USB serial converter, you need to enable<br /> USB Serial Converter support ---&gt;<br /> &lt;M&gt; USB FTDI Single Port Serial Driver (EXPERIMENTAL)<br /> in your kernel config.<br /> <br /> After loading the driver module manually by<br /> modprobe ftdi_sio<br /> you should find /dev/ttyUSB0 at your system<br /> <br /> * MessageLog (run 'dmesg')<br /> kernel: usb.c: new device strings: Mfr=1, Product=2, SerialNumber=3<br /> kernel: usb.c: USB device number 2 default language ID 0x409<br /> kernel: Manufacturer: GUDEADS<br /> kernel: Product: Expert mouseCLOCK USB II<br /> kernel: SerialNumber: FTPNFZVE<br /> kernel: usbserial.c: FTDI FT232BM Compatible converter detected<br /> kernel: usbserial.c: FTDI FT232BM Compatible converter now attached to '''ttyUSB0''' (or usb/tts/0 for devfs)<br /> <br /> For most recent linux distributions, you do not need to load the driver<br /> manually, thanks to hotplug daemons. In this case just plug the USB<br /> device and start working with /dev/ttyUSB0 .<br /> <br /> ----<br /> driver repository: http://ftdi-usb-sio.sourceforge.net/<br /> ----<br /> ==== &lt; BACK ====<br /> Were you installing NTPD? Get back to read on: [[Ntpd_Installation#Additional_kernel_mode_drivers]].</div>

Mb