SNMP eng

SNMP-get:Enables the acceptance of SNMP-GET commands.
SNMP-set:Allows the reception of SNMP-SET commands.
SNMP UDP Port:Sets the UDP port where SNMP messages are received.
sysContact:Value of RFC 1213 sysContact.
sysName:Value of RFC 1213 sysName.
sysLocation:Value of RFC 1213 sysLocation.
Enable SNMP v2:Activates SNMP v2.

Because of security issues, it is advisable to use only SNMP v3, and to disable SNMP v2. Accesses to SNMP v2 are always insecure.

Community public:The community password for SNMP GET requests.
Community private:The community password for SNMP SET requests.
Enable SNMP v3:Activates SNMP v3.
SNMP v3 Username:The SNMP v3 User Name.
SNMP v3 Authorization Algorithm:The selected Authentication Algorithm.
SNMP v3 Privacy Algorithm:SNMP v3 Encryption Algorithm..

If the password mask is redisplayed, only four "bullets" are shown as a symbolic placeholder, since for security reasons the device never stores the password itself, but only the key formed using the Authorization Algorithm. If you want to change a password, the complete password must always be re-entered.

The calculation of the password hashes varies with the selected algorithms. If the Authentication or Privacy algorithms are changed, the passwords must be re-entered in the configuration dialog. "SHA-384" and "SHA512" are calculated purely in software. If "SHA-512" is set on the configuration page, the time for the key generation may take once up to approx. 45 seconds.

Send SNMP traps:Here you can specify whether, and in what format the device should send SNMP traps.
SNMP trap receiver:You can insert here up to eight SNMP trap receiver.
MIB table:The download link to the text file with the MIB table for the device.
More information about SNMP settings are available from our support or can be found on the Internet at www.gude.info/wiki.