Install the firmware update without switching the power ports
Version vom 5. Mai 2026, 09:53 Uhr von Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „The EPC can switch back and forth between the bootloader and the firmware without a cold boot by pressing the ‘select’ and ‘ok’ buttons simultaneously.…“)
The EPC can switch back and forth between the bootloader and the firmware without a cold boot by pressing the ‘select’ and ‘ok’ buttons simultaneously.
The following is required for this:
Bootloader >= v2.2 EPC firmware >= v2.1.12
Hold both buttons down simultaneously until the status LED flashes. You are now in bootloader mode. After a firmware update, hold both buttons down again until the status LED stops flashing to start the firmware.
This allows you to perform a firmware update without having to switch the power ports.