Neue Seiten
Zur Navigation springen
Zur Suche springen
- 10:03, 5. Mai 2026 What does the status LED indicate? (Versionen | bearbeiten) [706 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „Status LED in firmware mode Status LED red: Ethernet connector not connected Status LED orange: Ethernet connector connected, waiting for DHCP respons…“)
- 09:57, 5. Mai 2026 Reset to factory settings (Versionen | bearbeiten) [1.702 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „How can the device be reset to factory settings? == Using the Select/OK button (cold start) == # During the cold start, hold down the '''Select''' button unti…“)
- 09:53, 5. Mai 2026 Install the firmware update without switching the power ports (Versionen | bearbeiten) [887 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „The EPC can switch back and forth between the bootloader and the firmware without a cold boot by pressing the ‘select’ and ‘ok’ buttons simultaneously.…“)
- 09:04, 5. Mai 2026 What to do if you forget your password? (Versionen | bearbeiten) [1.870 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „= Full Factory Reset = If you have forgotten the HTTP password for your ‘’'GUDE'‘’ switchgear, you can reset the device to its factory settings to rega…“)
- 08:51, 5. Mai 2026 EPC SNMP (Versionen | bearbeiten) [11.429 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „=General Information= *SNMP can be used on the '''EPC''' ** to retrieve status information and, if applicable, sensor data via UDP (port 161) ** to switch the…“)
- 08:36, 5. Mai 2026 Access Control via IP ACL (Versionen | bearbeiten) [1.938 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „=IP '''A'''ccess '''C'''ontrol '''L'''ist= The IP ‘''A'''ccess '''C'''ontrol '''L'''ist (IP ACL for short) allows you to restrict access to specific subnets…“)
- 08:31, 5. Mai 2026 HTTP password encryption (Versionen | bearbeiten) [937 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „==How is the HTTP password encrypted?== * In the past, Gude devices only supported HTTP Basic Access Authentication for password authentication. Now, cookie-ba…“)
- 15:22, 3. Mär. 2026 HTTP-Passwort-Verschlüsselung (Versionen | bearbeiten) [1.017 Bytes] Lh (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „==Wie wird das HTTP Passwort verschlüsselt?== Das Passwort wird via [http://www.ietf.org/rfc/rfc2617.txt HTTP AuthType Basic] übermittelt, was einer Base64 K…“) ursprünglich erstellt als „FAQ HTTP Authentifizierung“